The summary curve calculator is a tool to do relative simple vector calculations on a set of curves. The created curves can be stored for later use in the project.

The calculator can be run by pressing the calculator icon in the menu bar, or by right-clicking on either a summary case or the summary plot collection.

Calculation Settings

To make a new calculated curve, click on New Calculation. This will add a new calculation to Calculated Summaries. Before choosing which curves to do calculations on, a calculation expression must be made. The default expression Calculation_1 := x + y will do a vector addition on the curves which x and y are placeholders for, and assign it to the calculation Calculation_1. How to assign curves to assign to x and y will be covered in section Summary Address Selection.

Operators and Functions

Possible operations and functions are found by right-clicking in the expression window. The following tables show all the options available.

Assignment Operators

:= Assign

Basic Operators

+ Addition
- Subtraction
* Multiplication
/ Division
% Modulus
^ Power

Scalar Functions

avg Average
max Maximum
min Minimum
sum Sum

Trigonometry Functions

acos Arc cosine (in radians)
acosh Inverse hyperbolic cosine (in radians)
asin Arc sine (in radians)
asinh Inverse hyperbolic sine (in radians)
atan Arc tangent (in radians)
atanh Inverse hyperbolic tangent (in radians)
cos Cosine
cosh Hyperbolic cosine
cot Cotangent
csc Cosecant
deg2rad Convert x from degrees to radians
deg2grad Convert x from degrees to radians
rad2deg Convert x from radians to degrees
grad2deg Convert x from radians to degrees
sec Secant
sin Sine
sinc Sine cardinal
sinh Hyperbolic sine
tan Tangent
tanh Hyperbolic tangent

Vector Functions

abs Absolute value
ceil Rounding up
floor Rounding down
frac Fractional portion of input
log Natural logarithm
log10 Base 10 logarithm
pow Power
round Round x to the nearest integer
sgn Sign of x, -1 where x < 0, +1 where x > 0, else zero
sqrt Square root
trunc Integer portion of input


It is possible to add a unit to the calculated curve, in the field Unit beneath the expression field. This will be used as the label on the y-axis when the curve is used in a plot.

Summary Address Selection

An expression consists of placeholders (variables) for curves (summary address). By clicking Parse Expression, the variables will appear in the table below the settings. To assign a summary address to a variable, click Edit. This action will open a Summary Address Selection dialog. Use the dialog to select a summary address and press OK. Repeat the procedure for all the variables.

Generating Curves

After assigning summary addresses to all variables, click Calculate to evaluate the expression. The curve is saved and can be accessed in the Plot Editor selecting the Summary Type: Calculated.

The curves can also be found in an existing curve’s Property Editor. Choose the case Calculated, and the curves will appear in Vector Selection.