The results mapped on the 3D model can be inspected in detail by left clicking cells in the 3D view. The selected cells will be highlighted, text information displayed in the Result Info docking window, and the time-history values plotted in the Result Plot, if available.

Visibility of the docking widows can be controlled from the Windows menu.

Result Info

Clicking cells will display slightly different information text based on the case type as described in the following tables.

Eclipse Model

Geometry Description
Reservoir cell Displays grid cell result value, cell face, grid index and IJK coordinates for the cell. The intersection point coordinates is also displayed. Additional result details are listed in the section – Grid cell result details –
Fault face Displays the same info as for a Reservoir cell. In addition the section – Fault result details – containing Fault Name and Fault Face information.
Fault face with NNC Displays the same info as Fault face, except the Non Neighbor Connections (NNC) result value is displayed instead of grid cell value. Information added in section – NNC details – is geometry information of the two cells connected by the NNC.
Formation names Displays name of formation the cell is part of

Geomechanical Model

Name Description
Closest result Closest node ID and result value
Element Element ID and IJK coordinate for the element
Intersection point Location of left-click intersection of the geometry
Element result details Lists all integration point IDs and results with associated node IDs and node coordinates
Formation names Displays name of formation the cell is part of

Result Plot

If a dynamic none-Flow Diagnostics result is active, the result values of the selected cells for all time steps are displayed in the docking window Result Plot as one curve for each cell.

Additional curves can be added to the plot if CTRL-key is pressed during picking. The different cells are highlighted in different colors, and the corresponding curve is colored using the same color.

To clear the cell-selection, left-click outside the visible geometry.

Adding the Curves to a Summary Plot

The time history curves of the selected cells can be added to a Summary Plot by right-clicking in the Result Plot or in the 3D View.

A dialog will appear to prompt you to select an existion plot, or to create a new one.

PVT Plot

Show the PVT Plot window by selecting Windows -> PVT Plot.

The PVT plot window shows two plots, based on PVTNUM in the selected cell. One plots Phase Formation Volume Factor and the other plots Phase Viscosity, both against pressure. The Phase can be either oil or gas, and can be selected in the top left corner of the window.

Pressure for the selected cell, at the current time step, is marked on the plot as a vertical line, and a large circle marks the scalar value of the cell (formation volume factor/viscosity). RV for the selected cell is also shown.

Relative Permeability Plot

Show the Relative Permeability Plot window by selecting Windows -> Relative Permeability Plot.

The Relative Permeability Plot window shows up to six curves, based on SATNUM in the selected cell. The curves can be turned on/off in the top left corner of the window, and they are described in the following table:

Name Description Axis
KRW Relative permeability water KR (Left)
KRG Relative permeability gas KR (Left)
KROW Relative permeability oil water KR (Left)
KROG Relative permeability oil gas KR (Left)
PCOW Capilar pressure oil water PC (Right)
PCOG Capilar pressure oil gas PC (Right)

Saturation of water and gas in the selected cell, at the current time step, are annotated in the plot by a blue and orange vertical line, respectively. The intersections between the lines and the relevant curves are marked with large circles.